The modern approach to plastering works is not much different from the “old-fashioned methods”. But the world does not stand still and with the advent of new materials, there are also changes in technological processes. Plastering work is no exception. Below is a detailed description of wall alignment..
To work we need the following tools:
- level
- the rule
- trowel
- spatulas
- solution container
The plaster mixture itself is ready-made in bags and is simply diluted with water.
We begin work with the preparation of the foundation. To avoid cracks, it is necessary to use a special mesh, which is attached to the base with tile glue..
In order for our plane to be perfectly flat, we start work with the installation of lighthouse rails. On the primed surface, apply the plaster mixture pointwise.
Then we start installing the lighthouse rail.
Be sure to check the level.
And by a long rule.
Remove the remains of the gypsum mixture with a spatula.
We leave the lighthouses to dry for a couple of hours.
We knead the plaster solution in any container using a mixer.
Apply the finished solution with a trowel between the lighthouse rails and remove the excess using the rule.
We get a rough surface.
In order to prepare our plane for further finishing, we apply a thin layer of gypsum mixture to the dried plaster with a spatula.
As a result, we get a smooth, high-quality wall, ready for any further finishing.
Can someone please provide a step-by-step guide on how to plaster walls on your own? I’m interested in tackling this project but could use some guidance!
Sure! Here’s a step-by-step guide for plastering walls:
1. Prepare the wall: Remove any wallpaper, dirt, or loose paint. Make sure the surface is clean and dry.
2. Prime the wall: Apply a coat of primer to improve plaster adhesion and prevent absorption.
3. Mix the plaster: Follow the instructions on the plaster bag to mix it with water until you achieve a smooth, creamy consistency.
4. Apply the first coat: Use a plastering trowel to apply the plaster in a thin layer, called the scratch coat. Work from bottom to top, using upward strokes.
5. Create a textured surface: Use a plasterer’s float to create a rough surface on the scratch coat, allowing the next coat to stick better.
6. Apply the second coat: Once the scratch coat is dry (usually overnight), apply a second coat known as the finishing coat. This coat should be slightly thicker than the scratch coat.
7. Smooth the surface: Use a straight edge or a float to level the plaster, ensuring an even finish.
8. Allow it to dry: Let the plaster dry completely, which typically takes a few days. Avoid touching or disturbing it during this time.
9. Sand and polish (optional): If desired, lightly sand the dried plaster to remove imperfections, and then polish the surface with a damp sponge for a smoother finish.
10. Paint or decorate: Once the plaster is fully dry, you can paint, wallpaper, or decorate the wall as desired.
Remember, plastering can be a skill that requires practice. It’s important to take your time, be patient, and refer to detailed tutorials or seek professional advice if needed.