This article describes step by step the process of dismantling the old chuck and replacing it with a new one using the example of the Einhell 550E hand drill. The reason for the replacement was the split body of the chuck, as a result, the inability to firmly grip the drill.
Execution order
De-energize the tool.
Open the chuck petals completely. Since the fixed part of the body is broken, we hold the spindle of the drill with a 14 key.
We inspect the fixing screw for the integrity of the cross groove.
Use a screwdriver to unscrew the fixing screw clockwise, since the thread on it is with left-hand thread.
Tip: if the cross groove is partially lapped, you can hit it several times with a screwdriver before unscrewing it, this will allow you to slightly correct the groove.
We hold the spindle with the 14th key, unscrew the faulty chuck counterclockwise.
Holding the spindle with a key, we wind the new chuck clockwise until it stops, holding it by the fixed part, and clamp it with force.
Holding the chuck by the fixed part, tighten the screw with a screwdriver counterclockwise until it stops.
The result of the work done
The entire replacement work took no more than five minutes, and the result was pleasing. The drills are perfectly clamped in the chuck and can be changed quickly and easily. When drilling, the drill does not turn in the chuck and does not hit.
Is it difficult to replace the cartridge on an electric drill? What steps should be followed to ensure a successful replacement? Are there any specific tools or precautions that should be taken? Can you provide a step-by-step guide or recommend any resources for further assistance?
Is it possible to replace the cartridge in an electric drill without any prior experience or training?
Can you provide step-by-step instructions on how to replace the cartridge with an electric drill? Iโve never done it before and would appreciate your guidance.